Xecuter LT Switch *ENHANCED VERSION* - Liteon 74850 83850 93450 Read Write Switch
This is the new Xecuter LT Switch v1.5 – the latest version in the best selling Xecuter LT Switch range.
Now Includes MULTI-R Function. It was discovered that a small number of Liteon drives would not dump the firmware with a 20 ohm resistor – but required an 18 Ohm or 22 Ohm resistor - so now you can select between 18, 20 and 22 Ohms ! (Default should be set to 20 Ohms – this will work 99% of the time)
The installation is very simple and takes about 5 minutes if you have some small experience with a soldering iron. It has been tested with the latest Jungle Flasher 0.1.73. All Liteon drive versions have been tested with 100% Success (Including the troublesome Winbond IC). There is no need to remove the LT Switch after it has been installed – simply switch to normal mode and you are good to go. Even if you have to upgrade in the future – you don’t have to touch the switch again !
- Enables Read/Write on Liteon 74850, 83850, 93450 DVD Drives
- Easy Install
- Enable / Disable Switch
- On/Off LED
- No Need To Uninstall
- Works with all tools including latest Jungle Flasher
- Redesigned circuit to give a cleaner filter when switching to Vendor mode. No more read errors !
- Enlarged solder points to give an easier flow to the Liteon PCB points - Noob friendly !
- Added Read/Write Mode LED (RED)
- Added Normal 360 Mode LED (Green)
- Upgrade the switch to a stronger more robust model
- Changed location of LED so they can be viewed when Liteon PCB is installed to its case
- Slight improvement to the PCB shape so it sits firmly and accurately in place when soldering.
The good news is it works 100% with all Liteon drive versions and tested with 100% Success. There is no need to remove the LT Switch after it has been installed - simply switch to normal mode. great news if there is a new firmware released..
| Installation Diagram |
 |
|
